Allied-telesis AlliedView-EMS 4.0.2 Device-Manager Manual de usuario Pagina 409

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 441
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 408
AlliedView™-EMS 4.0.2 Device Management Guide Page 409 of 441
LED State Description
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The Module Name parameter always displays 'yyyyyyyy' as its default value when not
yet configured.
Note - AT-CV5M01: The current firmware version does not allow the Port Mode
parameter of FX type of ports to be configured. Attempting to configure this parameter
other than its current Port Mode value will result in the error message: "noSuchName."
AT-CM202 and AT-CM202/x
AT-CM202: 10/100TX to 100FX (SC, 2km, MM)
AT-CM202/1: 10/100TX to 100FX (SC, 15km, MM)
AT-CM202/2: 10/100TX to 100FX (SC, 40km, MM)
LED State Description
DUP
Green
Orange
The port is operating in full-duplex mode.
The port is operating in half-duplex mode.
LT Green Link Test is enabled
SML Green Smart Missing Link is enabled
ML Green Missing Link is enabled
OAMB Green OAM Bypass is enabled
OAMV Green OAM Visible is enabled
LCDS Green Line Card Dip Switch is enabled
Note - The Module Name parameter always displays 'yyyyyyyy' as its default value when not
yet configured.
Vista de pagina 408
1 2 ... 404 405 406 407 408 409 410 411 412 413 414 ... 440 441

Comentarios a estos manuales

Sin comentarios