Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT Manual de usuario descargar pdf (Pagina 296)

AlliedView™-EMS 3.10 Device Management Guide Page 296 of 367

Port Info

Note - Even if the current firmware version allows the Port Mode, Port Speed and

Port Duplex Status parameters to be configured to certain values, these parameters

should not be configured for the 100Base-FX port.

Note - The value of the Port Mode parameter of a port with an established link

automatically changes to 'auto' when the settings of the port to which it is

connected are modified.

Note - The value of the Port Speed parameter of a port with an established link

automatically changes to '10Mbps' when the value of its Port Mode parameter is

changed from 'auto' to 'manual'.

Remote Port Info

Note - If connection is established on the 100Base-FX port, the current firmware

version is unable to return the correct value for the Remote Module Revision and

Remote Port Ingress Rate Limit parameters.

AT-CM2K0S

10/100/1000T to SFP

LED State Description

DUP

Green

Orange

The port is operating in full-duplex mode.

The port is operating in half-duplex mode.

LT Green Link Test is enabled

SML Green Smart Missing Link is enabled

ML Green Missing Link is enabled

OAMB Green OAM Bypass is enabled

OAMV Green OAM Visible is enabled

LCDS Green Line Card Dip Switch is enabled

Port Info

Note - The value of the Port Mode parameter of a port with an established link

automatically changes to 'auto' when the settings of the port to which it is

connected are modified.

1 2 ... 291 292 293 294 295 296 297 298 299 300 301 ... 366 367

Sin comentarios

Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT Manual de usuario Pagina 296