Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT Manual de usuario descargar pdf (Pagina 290)

AlliedView™-EMS 3.10 Device Management Guide Page 290 of 367

Device Manager LEDs for Converteon Chassis

LED State Description

FAN2

(AT-CV5000)

Green

Gray

FAN 2 is installed and power is on.

FAN 2 is not installed or it is installed but not powered on.

Note - Please refer to Converteon Series Modules

for the operations and behavior of the

modules installed on the chassis.

Agent Menu

From the Agent Menu, you can view and edit the system information for the chassis, or log

into the CLI using Telnet.

System Info

Displays basic system information, including system name, location, contact and

description.

Note - The System Contact and System Name parameters accept inputs of up to 39

characters only while the System Location parameter accepts up to 38. Input values

that exceed these limits will be automatically truncated.

Network Info

Displays network-related information such as the addresses of the default gateway

and the TRAP Destination.

System Config

Displays the device's systems variables.

Note - The Temperature Threshold parameter is not applicable to the AT-CV1200

and should be ignored.

Note - AT-CV5000: CPM Switch Over can only be performed once - from primary

CPM to standby CPM. When this has been done, it will no longer be possible to

switch over from the standby CPM back to the primary CPM.

Note - When more than one CPM is installed on the chassis, resetting the primary

CPM card will automatically cause a switch over to the standby CPM.

Diagnostics

Displays the device's software version, fan speed and fan temperature.

Reset

Resets the device.

1 2 ... 285 286 287 288 289 290 291 292 293 294 295 ... 366 367

Sin comentarios

Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT Manual de usuario Pagina 290