Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGEMENT Manual de usuario Pagina 261

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 367
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 260
AlliedView™-EMS 3.10 Device Management Guide Page 261 of 367
will result in the error message: ”The error occurred with 'Set' operation. Error:
bad value.”
Server Info
Displays information about servers.
Note - The current firmware version does not allow the Authentication Key
parameter to be configured.
Note - The only valid MIB Set value for the Row Status parameter is ‘destroy’.
Attempting to set this parameter to any other value will result in the error
message: ”The error occurred with 'Set' operation. Error: bad value.”
Access Control List
Ethernet Info
Displays ACL mask of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
o Filtered Ports
o Source MAC Address Mask
o Destination MAC Address Mask
Ethernet Rule
Displays ACL rule of Ethernet information.
Note - The current firmware version does not allow the following parameters to be
configured:
o VLAN
o Source MAC Address
o Destination MAC Address
o Ethernet Type
IP Info
Displays ACL mask of IP information.
Note - The current firmware version does not allow the following parameters to be
configured:
o Filtered Ports
o TCP/UDP Source Port Mask
o TCP/UDP Destination Port Mask
o Protocol ID Mask
Vista de pagina 260
1 2 ... 256 257 258 259 260 261 262 263 264 265 266 ... 366 367

Comentarios a estos manuales

Sin comentarios