Allied-telesis AT-S80 Manual de usuario descargar pdf (Pagina 240)

Chapter 21: Basic Switch Parameters

240 Section II: Using the Web Browser Interface

Returning the AT-S80 Management Software to the Factory Default

Values

This procedure returns all AT-S80 Management Software parameters to

their default values. The default values are listed in Appendix A, “AT-S80

Software Default Settings” on page 339.

Caution

This procedure causes the switch to reboot. The switch does not

forward network traffic during the reboot process. Some network

traffic may be lost.

To return the AT-S80 Management Software to the default settings,

perform the following procedure:

1. From the Tools menu, select System Reboot.

The Reboot Page is shown in Figure 62 on page 236.

2. For the Reboot Type, select one of the following:

Reset to Factory Default

Resets all switch parameters to the factory default settings, including

IP address, subnet mask, and gateway address.

Reset to Factory Default Except IP Address

Resets all switch parameters to the factory default settings, but retains

the IP address, subnet mask, and gateway settings. If the DHCP client

is enabled, it remains enabled after this reset.

3. For the Reboot Status, select Start to start the reboot.

4. Click Apply.

The switch is rebooted. You must wait for the switch to complete the

reboot process before reestablishing your management session.

1 2 ... 235 236 237 238 239 240 241 242 243 244 245 ... 345 346

Sin comentarios

Allied-telesis AT-S80 Manual de usuario Pagina 240