Allied-telesis AT-S80 Manual de usuario Pagina 162
- Pagina / 346
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Chapter 13: Rapid Spanning Tree Protocol (RSTP)
162 Section II: Menus Interface
Configuring STP Compatibility
Choosing an RSTP protocol version allows you to determine if the switch
ports will operate in RSTP-only mode or are STP-compatible. This setting
applies to all of the ports; you cannot set this on a per-port basis.
To configure the STP compatibility, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type S to select Rapid
Spanning Tree Configuration.
The Rapid Spanning Tree Configuration Menu is shown in Figure 38
on page 157.
3. Type V to select Set RSTP Protocol Version.
The following prompt is displayed:
Set RSTP protocol version (S/R)>
4. Type S to make the ports STP-compatible, or R to make the ports
operate only in RSTP mode.
- User’s Guide 1
- Contents 3
- Document Conventions 15
- Contacting Allied Telesis 16
- Overview 17
- Management Overview 18
- Remote SNMP Management 20
- Management Access Level 21
- AT-FS750/24 Switch 22
- Using the Menus Interface 23
- Interface 25
- Enter system location> 37
- Enter system contact> 37
- Enter entry number> 40
- Enter new user name> 40
- Enter new password> 40
- Retype new password 42
- Retype new password> 42
- Viewing Switch Information 43
- Rebooting the Switch 46
- Enter new timeout value> 49
- Figure 12. Ping Results 50
- Chapter 4: Port Configuration 54
- Enabling and Disabling a Port 56
- Enter new mode for port 57
- (a/h/H/f/F/T)> 57
- Port Trunking Overview 62
- Trunk” on page 69 63
- (E/D)> 66
- Chapter 5: Port Trunking 68
- Enter trunk group number> 69
- IGMP Snooping Overview 72
- Setting the Age 76
- Setting Group 76
- Chapter 6: IGMP Snooping 78
- Static Multicast Address 79
- Adding a Static 81
- Multicast 81
- Deleting a Static 82
- Member Port 83
- Port Mirroring Overview 86
- Chapter 8: Port Mirroring 88
- Dial-in User Configuration 91
- Configuring a Dial-in User 93
- Deleting a Dial-in 94
- Modifying a 95
- VLAN Overview 98
- Port-based VLANs 99
- Tagged VLANs 99
- Port-based VLAN Overview 100
- Tagged VLAN Overview 101
- Port VLAN 102
- Identifier 102
- General Rules for 102
- Creating a 102
- Tagged VLAN 102
- Creating a VLAN 103
- Chapter 10: Virtual LANs 104
- Changing the 109
- Changing Port 110
- VLAN Type 110
- Displaying the VLANs 111
- Modifying a VLAN 114
- Enter new VLAN name> 115
- Deleting a VLAN 116
- Deleting a Tagged 117
- Chapter 11 119
- SNMP Overview 120
- Community String Attributes 121
- Creating an SNMP Community 124
- Deleting an 126
- Community 126
- Modifying an 127
- Enter community name> 128
- Creating an SNMP Host 129
- Deleting an Host 130
- Host Entry 131
- Enter IP address for host> 132
- Enabling an 133
- SNMP Trap 133
- Deleting a Trap 135
- Receiver 135
- Modifying a Trap 135
- Enabling or 137
- Disabling Traps 137
- Quality of Service (QoS) 139
- QoS Overview 140
- [T]raffic Class Configuration 143
- [P]ort Priority Configuration 143
- [Q]uit to previous menu 143
- Command> 143
- Chapter 13 149
- RSTP Overview 150
- Path Costs and Port Costs 151
- Port Priority 152
- Point-to-Point and Edge Ports 153
- Point-to-Point Ports 154
- (Full-duplex Mode) 154
- 87654321 155
- Rapid Spanning 156
- Tree and VLANs 156
- Enabling or Disabling RSTP 157
- Enter bridge priority> 160
- Enter bridge hello time> 160
- Enter bridge maximum age> 161
- Configuring STP Compatibility 162
- Configuring the 163
- Basic RSTP Port 163
- Settings 163
- Advanced RSTP 165
- Port Settings 165
- Displaying the RSTP Topology 168
- Bandwidth Control 171
- Bandwidth Control Overview 172
- Configuring Bandwidth Control 173
- Setting the 174
- Ingress Limit 174
- Setting Ingress 174
- DLF Status 175
- Chapter 14: Bandwidth Control 176
- IP Access List 177
- IP Access List Overview 178
- Configuring IP Access List 179
- Adding or 180
- Removing IP 180
- Addresses 180
- Destination MAC Filter 181
- Destination MAC 183
- Filtering 183
- Removing 184
- Chapter 17 185
- Authentication 187
- Authenticator 187
- Port-based 189
- Network Access 189
- Guidelines 189
- Switch A 191
- Switch B 191
- Guest VLANs 192
- Enter port number> 194
- Enter guest VLAN ID > 195
- Chapter 18 201
- RADIUS Overview 202
- Configuring the RADIUS Client 203
- Management Software Updates 207
- Enter file name > 210
- Enter retry count > 210
- Download file? (Y/N) > 210
- Section II 211
- Chapter 20 213
- Switch’s IP Address 214
- Web Browser Tools 217
- Basic Switch Parameters 219
- Setting Up the IP Access List 222
- Then click Add 223
- Deleting an IP 224
- Adding System 228
- Administration 228
- Information 228
- Modifying 229
- Deleting 230
- Viewing System Information 233
- Rebooting a Switch 236
- Pinging a Remote System 238
- 3. Click Start 239
- Port Configuration 241
- 10/100BaseTX - Base ports 243
- Port Trunking 245
- Creating a Port Trunk 246
- Modifying a Port Trunk 248
- Chapter 23: Port Trunking 250
- Port Mirroring 251
- Configuring Port Mirroring 252
- Disabling Port Mirroring 253
- Chapter 24: Port Mirroring 254
- Chapter 25 255
- Deleting a Group MAC Address 259
- IGMP Snooping 261
- Configuring IGMP Snooping 262
- Chapter 26: IGMP Snooping 264
- Chapter 27 265
- Removing a MAC Address 268
- Chapter 28: Bandwidth Control 272
- Virtual LANs 273
- Assigning Ports to a VLAN 274
- Creating a Tagged VLAN 275
- Chapter 29: Virtual LANs 276
- Modifying a Tagged VLAN 277
- Deleting a Tagged VLAN 279
- Creating a Port-Based VLAN 280
- Modifying a Port-Based VLAN 281
- Deleting a Port-Based VLAN 283
- Chapter 30 285
- Modifying an SNMP Community 287
- Deleting an SNMP Community 288
- Creating a Host Table 289
- Modifying a Host Table Entry 290
- Deleting a Host Table Entry 291
- Enabling or Disabling Traps 292
- Modifying Traps 293
- Deleting Traps 294
- Configuring CoS 298
- Chapter 32 301
- Basic RSTP Configuration 302
- Viewing the RSTP Topology 309
- Control Feature 311
- Dial-in User 317
- Adding a Dial-in User 318
- Modifying a Dial-in User 319
- Deleting a Dial-in User 320
- Chapter 35 321
- Statistics 329
- Displaying Switch Statistics 330
- Chapter 37: Statistics 332
- – Light Yellow 334
- – Light Gray 334
- Displaying Error 335
- Group Statistics 335
- Displaying 337
- Historical Status 337
- Appendix A 339
Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-S80
Hardware De La Computadora Allied-telesis AlliedView-EMS 3.10 VLAN MANAGER Manual de usuario
(71 paginas)
(71 paginas)
Hardware De La Computadora Allied-telesis AlliedView-EMS 3.10 DEVICE MANAGER Manual de usuario
(133 paginas)
(133 paginas)
Hardware De La Computadora Allied-telesis AT-CM20x Series Converteon Line Cards Manual de usuario
(2 paginas)
(2 paginas)
Hardware De La Computadora Allied-telesis AT-CM212x/1 Series Converteon Line Cards Manual de usuario
(2 paginas)
(2 paginas)
Hardware De La Computadora Allied-telesis AT-CM70S Converteon Line Cards Manual de usuario
(2 paginas)
(2 paginas)
Hardware De La Computadora Allied-telesis AT-CV10x Series Converteon Line Cards Manual de usuario
(2 paginas)
(2 paginas)
Hardware De La Computadora Allied-telesis AT-CV1KSS Converteon Line Card Manual de usuario
(2 paginas)
(2 paginas)
Hardware De La Computadora Allied-telesis AlliedView-EMS 3.10 QoS MANAGER Manual de usuario
(128 paginas)
(128 paginas)
Hardware De La Computadora Allied-telesis Telesyn AlliedView NMS System 9.0 Manual de usuario
(64 paginas)
(64 paginas)
© 2020, manymanuals.es. Todos los derechos reservados | 0.052 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales