Allied-telesis AT-S70 Manual de usuario Pagina 148

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 302
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 147
Chapter 9: SNMPv3
148
5. Enter a descriptive name of the user.
You can enter a name that consists of up to 32 alphanumeric
characters.
The following prompt is displayed:
Enter Authentication Protocol [M-MD5, S-SHA, N-None]:
6. Enter one of the following:
M-MD5
This value represents the MD5 authentication protocol. With this
selection, users (SNMP entities) are authenticated with the MD5
authentication protocol after a message is received. This algorithm
generates the message digest. The user is authenticated when the
authentication protocol checks the message digest. With the MD5
selection, you can configure a Privacy Protocol.
S-SHA
This value represents the SHA authentication protocol. With this
selection, users are authenticated with the SHA authentication
protocol after a message is received. This algorithm generates the
message digest. The user is authenticated when the authentication
protocol checks the message digest. With the SHA selection, you can
configure a Privacy Protocol.
N-None
This value represents no authentication protocol. When messages are
received, users are not authenticated. With the None selection, you
cannot configure a Privacy Protocol.
Note
You may want to assign NONE to a super user.
If you select NONE, you are prompted for the Storage Type. Proceed
to step 13.
If you select MD5 or SHA, the following prompt is displayed:
Enter Authentication Password:
7. Enter an authentication password (with a minimum of 8 and a
maximum of 32 alphanumeric characters) and press Return.
You are prompted to re-enter the password.
The following prompt is displayed:
Enter Privacy Protocol [D-DES, N-None]:
Vista de pagina 147
1 2 ... 143 144 145 146 147 148 149 150 151 152 153 ... 301 302

Comentarios a estos manuales

Sin comentarios