Allied-telesis AT-8202 Manual de usuario descargar pdf (Pagina 10)

Configuring the ATM Port

1-2

Configuring the ATM Port

This section describes the ﬁrst of a two-part process to conﬁgure the

ATM network.

To conﬁgure an ATM port, use the

ATM/CONFIG/MODIFY/PORT

command to display screen similar to Figure 1-1.

Figure 1-1

ATM Port Configuration Screen

Refer to Table 1-1 for a description of the port conﬁguration

parameters.

/ATM/CONFIG/MODIFY >PORT

ATM Port Configuration

1. ATM PVC/SVC Mode (PVC Mode (a), SVC Mode (b)): SVC Mode

2. Signaling Version (3.0(a), 3.1(b)): Uni 3.0

3. ILMI Enable (Enable(a), Disable(b)): Enable

4. ILMI Poll Enable (Enable(a), Disable(b)): Disable

5. Scrambling Enable (Enable(a), Disable(b)): Enable

6. Timing Mode (Loop(a), Local(b)): Local

Enter Selection, 0 to save the Modification or q to quit:

Table 1-1

ATM Port Conﬁguration Parameters

Parameter Description

PVC/SVC Mode Whether this port is conﬁgured for permanent virtual circuit or switched virtual

circuit mode

Signaling Version The FORMULA 8200 supports UNI 3.0 or UNI 3.1. Set this value depending

upon the UNI support on the ATM switch to which you have connected the

FORMULA 8200. Reboot the switch when the setting signaling version changes.

Default: UNI 3.0.

ILMI Enable ILMI provides network management (NMS) between an end-user and a public

or private network. ILMI functions for conﬁguration, status, and control

information about the physical and ATM layer parameters are available for the

ATM interface.

Options: Enable or disable

Default: Enable

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 79 80

Sin comentarios

Allied-telesis AT-8202 Manual de usuario Pagina 10