Allied-telesis 8100S Series Manual de usuario descargar pdf (Pagina 86)

Chapter 5: Assigning the Stack ID Numbers and Cabling the Stacking Ports

4. Type Y to change the switch’s ID number and reset the unit, or N to

cancel the procedure.

5. Wait for the switch to initialize its management software and

afterwards examine the Stack ID LED again to confirm that it’s

displaying the correct stack ID number for the switch. For example, if

in step 3 you assigned the switch the ID number 2, then the stack ID

LED should be displaying the number 2.

6. Disconnect the AC power cord from the switch and the power source.

7. Return to “Powering on a Switch” on page 80 to verify and set the

stack ID number of the next switch in the stack. If there are no further

switches, go to “Cabling the Stacking Ports” on page 87.

1 2 ... 81 82 83 84 85 86 87 88 89 90 91 ... 139 140

Sin comentarios

Allied-telesis 8100S Series Manual de usuario Pagina 86