Allied-telesis 8100S Series Manual de usuario descargar pdf (Pagina 72)

Chapter 4: Installing and Labeling the Switches in an Equipment Rack

Installing the Switches in an Equipment Rack

This procedure requires the following items:

 Eight bracket screws (included with the switch)

 Two equipment rack brackets (included with the switch)

 Flat-head screwdriver (not provided)

 Cross-head screwdriver (not provided)

 Four standard equipment rack screws (not provided)

Perform this procedure to install the switch in a 19-inch equipment rack,

Caution

The chassis may be heavy and awkward to lift. Allied Telesis

recommends that you get assistance when mounting the chassis in

an equipment rack.  E28

1. Place the unit upside down on a level, secure surface.

Figure 21. Turning the Switch Upside Down

2. Using a flat-head screwdriver, pry the rubber feet from the bottom of

the switch.

Figure 22. Removing the Rubber Feet

3. Turn the switch over.

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 139 140

Sin comentarios

Allied-telesis 8100S Series Manual de usuario Pagina 72