Allied Telesis AT-S80 Guía de usuario descargar pdf (Pagina 87)

AT-S80 Management Software User’s Guide

Section I: Using the Menus Interface 87

3. From the VLAN Management Menu, type C to select Create VLAN.

The VLAN Creation Menu is shown in Figure 21.

Figure 21. VLAN Creation Menu

4. Type I to select Set VLAN ID/Index.

The following prompt is displayed:

Set VLAN ID->Enter VLAN ID>

Note

A VLAN must have a VID.

5. Enter a value from 2 to 4094 and press Enter.

If this VLAN will be unique in your network, then its VID should also be

unique. If this VLAN is part of a larger VLAN that spans multiple

switches, than the VID value for the VLAN should be the same on each

switch. For example, if you are creating a VLAN called Sales that

spans three switches, you should assign the Sales VLAN on each

switch the same VID value. To prevent inadvertently using the same

VID for two different VLANs, you should keep a list of all your network

VLANs and their VID values.

6. Type N to select Set VLAN Name.

AT-FS750/16 Local Management System

VLAN Management -> VLAN Creation Menu

VLAN ID :

VLAN Name:

Port Member

----------------------------------------------------------------------

------------------------- <COMMAND> ----------------------------------

Set VLAN [I]D/[I]ndex [S]elect Port Member

Set VLAN [N]ame [A]pply

[Q]uit to Previous Menu

Command>

1 2 ... 82 83 84 85 86 87 88 89 90 91 92 ... 241 242

Sin comentarios

Allied Telesis AT-S80 Guía de usuario Pagina 87