Allied Telesis AT-S80 Guía de usuario descargar pdf (Pagina 192)

Chapter 17: Port Trunking

192 Section II: Using the Web Browser Interface

Modifying a Port Trunk

This procedure adds and removes ports from a port trunk.

Caution

Disconnect the cables from the ports of the trunk before you modify

the trunk. Leaving the cables connected can create a loop in the

network topology. A loop can cause a broadcast storm and poor

network performance.

Note

You cannot modify Trunk 7, which is reserved for the uplink ports. If

you want to use the uplink ports as a port trunk, activate Trunk 7 as

explained in “Enabling and Disabling a Port Trunk” on page 193.

To add or remove ports from a trunk, perform the following procedure:

1. From the Advanced Config menu, select Trunk Config.

The Trunk Configuration page is shown in Figure 55.

2. Click the status of the port trunk to be modified and change the status

from Enable to Disable.

Note

Allied Telesyn recommends disabling a port trunk before adding or

removing ports.

3. Click Apply.

4. To add or remove a port from a trunk, click the dialog box for the port

in the corresponding trunk row. A check in a box indicates the port is a

member of the trunk. No check means the port is not a member.A port

trunk can contain up to eight ports.

5. Click Apply.

6. Modify the port trunk on the other switch and reconnect the cables.

1 2 ... 187 188 189 190 191 192 193 194 195 196 197 ... 241 242

Sin comentarios

Allied Telesis AT-S80 Guía de usuario Pagina 192