Allied Telesis AT-ANC10S/4 Guía de instalación descargar pdf (Pagina 114)

Chapter 10: User Diagnostics

114

Performing Diagnostics

At the MS-DOS prompt, type uediag followed by the command options.

The uediag command options are shown in Table 10. For example, to run

all of the diagnostic tests except Group B tests on adapter #1, enter:

C:\>uediag -c 1 -t b

Note

You must include uediag at the beginning of the command string

each time you type a command.

Note

Not all commands are supported on all adapters.

Table 10. uediag Command Options

Command Option Description

uediag Performs all tests on all the ANC10S

networks adapters in your system.

uediag -c <devnum> Specifies the adapter (devnum) to test.

Use all in place of a specific device

number to test all adapters.

uediag -cof Allows tests to continue after detecting

a failure.

uediag -F Forces an upgrade of the image

without checking the version.

uediag -fbc <bc_image> Specifies the bin file to update the

bootcode.

uediag -fipmi

<ipmi_image>

Specifies the bin file to update IPMI

firmware.

uediag -fmba

<mba_image>

Specifies the bin file to update the

MBA.

uediag -fncsi

<ncsi_image>

Specifies the bin file to update the

NCSI firmware.

uediag -fnvm

<raw_image>

Programs the raw image into NVM.

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 129 130

Sin comentarios

Allied Telesis AT-ANC10S/4 Guía de instalación Pagina 114