Allied Telesis AT-ANC10S/4 Guía de instalación descargar pdf (Pagina 112)

Chapter 10: User Diagnostics

112

Overview

Broadcom NetXtreme II User Diagnostics is an MS-DOS based

application that runs a series of diagnostic tests. These tests allow you to

update device firmware as well as to view and change settings for

available adapter properties.

Note

The diagnostics utility is available from the Allied Telesis web site at

www.alliedtelesis.com/support/software.

To run Broadcom NetXtreme II User Diagnostics, you must create an MS-

DOS 6.22 bootable disk containing the uediag.exe file. Next, start the

system with the boot disk in drive A. See the following sections:

 For a list of system requirements to run the diagnostic tests, see

“System Requirements” on page 113.

 For instructions how to run diagnostic tests on the AT-ANC10S/2

and AT-ANC10S/4 adapters, see “Performing Diagnostics” on

page 114.

 For descriptions of the available diagnostic tests, see “Diagnostic

Test Descriptions” on page 117.

1 2 ... 107 108 109 110 111 112 113 114 115 116 117 ... 129 130

Sin comentarios

Allied Telesis AT-ANC10S/4 Guía de instalación Pagina 112