Allied Telesis AT-2450 Series Guía de instalación descargar pdf (Pagina 83)

Network Adapter Card Installation Guide

System

Requirements

To run AT-Stat, your system must be operating in either Windows 2000

or XP and have an Allied Telesyn network adapter card and driver

installed.

Installing AT-Stat

To install AT-Stat, perform the following procedure:

Note

The adapter driver for an AT-2450, AT-2500, AT-2501, AT-2700, or

AT-2701 Series network adapter card must be updated to obtain

custom statistics. Otherwise, only generic statistics are available. To

update an adapter driver, refer to Updating a Network Adapter

Driver on page 57.

1. Insert the CardAssistant CD into the CD-ROM drive.

The CardAssistant Main Menu shown in Figure 59 is displayed. If this

menu is not displayed, double-click on the My Computer icon, then

double-click on the Allied Telesyn CD-ROM icon.

Figure 59 CardAssistant CD Main Menu

2. From the Driver Setup drop-down menu, select the adatper card

that you purchased.

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 121 122

Sin comentarios

Allied Telesis AT-2450 Series Guía de instalación Pagina 83