
14 Patch Release Note
Patch 89262-09 for Software Release 2.6.2
C613-10402-00 REV I
If a timed-out ARP entry was renewed by BOOTP, the new entry be created
with no port association. This issue has been resolved.
Level 3
When an accelerator card is installed, and ports had been configured for
mirroring, the enable switch mirror caused an unnecessary warning
message to be displayed. This issue has been resolved.
When an accelerator card is installed, the set switch mirror command
caused the switch to display an incorrect message saying that the maximum
port number is 54. This issue has been resolved.
In certain scenarios when acting as a DHCP server, the switch would send
a DHCP ACK to an invalid MAC address. This issue has been resolved.
When a virtual link end point is no longer reachable, the virtual interface is
not brought down, and the virtual neighbour is not removed. This issue has
been resolved.
Setting switch enhanced mode to “none” in order to disable QoS counters
did not disable the QoS counters properly. A debug error message was
shown when attempting to view the traffic class counters. This debug error
message has now been removed and an appropriate error message is now
displayed.
When MIB counters relating to packet flows reached their maximum
possible value (0xFFFFFFFF), they should have returned to 0, and counted
up from 0 again. However, they were remaining stuck at 0xFFFFFFFF.
This issue has been resolved, so that the counters will correctly roll over
from 0xFFFFFFFF to 0 and start counting up again.
Level 4
No issues.
Enhancements
The RSTP module has been enhanced to detect simple loop scenarios
downstream of an RSTP enabled edge port. If a loop is detected, the port is
PCR: 40592 Module: BOOTP Level: 2
PCR: 40471 Module: SWI Level: 3
PCR: 40474 Module: IPG Level: 3
PCR: 40493 Module: DHCP Level: 3
PCR: 40498 Module: OSPF Level: 3
PCR: 40515 Module: QoS Level: 3
PCR: 40525 Module: SWI, SWX Level: 3
PCR: 40511 Module: RSTP
Comentarios a estos manuales