Allied Telesis AT-MC105XL Guía de instalación descargar pdf (Pagina 24)

10. Set the MDI/MDI-X switch as follows. (Refer to Figure 8 for the location of

the switch.)

Figure 8 MDI/MDI-X Switch

— If you are connecting a workstation to the 100Base-TX port, set the

MDI/MDI-X switch to the MDI-X position. (MDI-X is the default.)

— If you are connecting a hub or switch to the 100Base-TX port, set the

MDI/MDI-X switch to the MDI position.

11. Power ON the end-nodes.

12. Check that the LNK LEDs for both ports on the media converter are

green. If the LEDs are OFF, refer to “Troubleshooting” on page 15.

The media converter is now ready for use.

Warranty Registration

When you are finished installing the product, you should register your product

by completing the enclosed warranty card and sending it in. You can also fill

out the registration online by selecting “Warranties” under “Support &

Services” at www.alliedtelesyn.com.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 41 42

Sin comentarios

Allied Telesis AT-MC105XL Guía de instalación Pagina 24