Allied-telesis x610 Series Layer 3 Manual de usuario descargar pdf (Pagina 48)

Chapter 1: Overview

Terminal Port

The terminal port is used to establish a local (out-of-band) management

session with the switch. You establish a local management session by

connecting a terminal or a personal computer with a terminal emulation

program to the port.

The terminal port has an RJ-45 style connector. An RJ-45 to RS-232

management cable is supplied with the switch.

The terminal port is set to the following specifications:

 Default baud rate: 9600 bps (Range is 9600 to 115200 bps)

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

See Table 22 on page 127 for the pin signal definitions on the RJ-45 port.

Note

These settings are for a DEC VT100 or ANSI terminal, or an

equivalent terminal emulation program.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 127 128

Sin comentarios

Allied-telesis x610 Series Layer 3 Manual de usuario Pagina 48