Allied-telesis x310 Series Manual de usuario descargar pdf (Pagina 78)

Chapter 4: Installing the Switch on a Wall

You should install the plywood base to the wall and then install the switch

on the base. Refer to Figure 35.

Figure 35. Steps to Installing the Switch with a Plywood Base

Wall Guidelines Here are the guidelines to installing the AT-x310-26FP, AT-x310-50FT,

and AT-x310-50FP Switches on a wall.

 You may install the switch on a wall that has wooden studs.

 You may install the switch on a concrete wall.

 If you are installing the switch on a wall with wooden studs, you

should use a plywood base to support the switch. For more

information, refer to “Plywood Base for a Wall with Wooden Studs”

on page 75. A plywood base is not required for a concrete wall.

 You should not install the switch only on sheetrock or similar

material. Sheetrock is not strong enough to safely support the

device.

Step 1: Install the

plywood base to

the wall.

Step 2: Install the

switch on the

plywood base.

Wall

Plywood

Base

1 2 ... 73 74 75 76 77 78 79 80 81 82 83 ... 115 116

Sin comentarios

Allied-telesis x310 Series Manual de usuario Pagina 78