Allied-telesis x310 Series Manual de usuario Pagina 104

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 116
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 103
Chapter 6: Powering On the Switch
104
Figure 58. Saving the Changes with the WRITE Command
9. Enter the REBOOT command to reboot the switch.
10. At the confirmation prompt, type “Y” for yes.
11. Wait for the switch to initialize its management software and
afterwards examine the Switch ID LED. If the ID number is “0,” the
switch is ready for normal network operations as a stand-alone unit.
Refer to the Software Reference for x310 Series Switches, AlliedWare
Plus Operating System, for instructions on how to configure the
operating parameters. If the number is not “0,” repeat this procedure.
awplus# write
Building configuration ...
[OK]
awplus#
Vista de pagina 103
1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 115 116

Comentarios a estos manuales

Sin comentarios