Allied-telesis FORMULA 8200 Manual de usuario Pagina 10
- Pagina / 164
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
Preface
x
Document Conventions Used in This Guide
This section describes the typographic conventions used in this
guide.
Note
The command line interface (CLI) portion of the FORMULA 8200 is not
case sensitive; however, this manual shows commands in uppercase
letters. You may type your commands in either uppercase or
lowercase, as shown in some of the examples.
This guide uses the following symbols to highlight special messages:
Note
A note includes information of importance or special interest.
Caution
A caution includes information that will help you prevent
equipment
failure or loss of data
.
Example Meaning
Local IP configuration
:
The
VLAN/CONFIG/CREATE
command is used
to configure a VLAN.
Enter
BRIDGE <VLAN#>
.
Press the
[Enter]
key to execute a command.
System prompts and messages are shown in
COURIER
font..
Commands or other input the user must supply are
shown in
BOLDFACE
capital letters.
Text in angle brackets after a command indicates user-
defined input must follow the command. (Example:
BRIDGE 2
)
Keys named in text are shown enclosed in square
brackets. (
[Enter]
is used to denote both the
Enter
key and the
Return
key.)
Read Chapter 6 in the
User Guide
. Book titles are shown in
italic
type.
To install the switch on a
flat surface:
1. User action
2. User action
The Procedure icon denotes a series of numbered
steps the user must perform. Each step may be
followed by text that explains the result of the user
action.
- USER’S GUIDE 1
- Table of Contents 3
- Chapter 3 4
- Chapter 4 4
- Who Should Use This Guide 8
- How This Guide Is Organized 9
- To install the switch on a 10
- Related Documents 11
- Recommended Reading 12
- Overview 15
- Accessing the Command Line 17
- Interface (CLI) 17
- Connecting the Console 18
- Observing the 20
- Logging In 22
- Without a 23
- Password 23
- To log in without a password: 23
- Entering Commands 24
- The LOOKUP 25
- Through the 26
- Configuring IP Information 27
- (example): 30
- Where to Go Next 31
- Configuring the FORMULA 8200 33
- Virtual LANs 34
- FORMULA 8200 35
- Implementation 35
- of VLANs 35
- Figure 3-2: Multiple VLANs 36
- Virtual Bridges 37
- Interfaces 37
- Virtual Routers 37
- Figure 3-3: Data Looping 38
- To configure a VLAN: 40
- to move one or more ports 41
- VLAN/SHOW/VLAN 2 42
- Configuring a Virtual Bridge 43
- Operating and Managing the 47
- FORMULA 8200 Switch 47
- Using Online Help 48
- Using Ethernet Port Mirroring 55
- 1 0 Receive 56
- 0 0 Reset (clear snoop port) 56
- /VBRIDGE/SHOW/PORT 1 63
- VLAN ARL 64
- /ETHERNET/SHOW/SRCCNT 64
- Upgrading Firmware 65
- In Case of 71
- Problems With 71
- Modifying the IP RIP Mode 73
- Configuring Static Routes 74
- Configuring SNMP Parameters 76
- Displaying SNMP Parameters 77
- ATM and FDDI Support 83
- Command Edit Mode 84
- ALIAS Command 85
- ALLCMD Command 86
- ATM Command 87
- BOOT Command 88
- CONSOLE Command 90
- command: 91
- ELOG Command 92
- ETHERNET Command 95
- display 100
- ETHERNET/SHOW/STAT Example 101
- Use the 101
- EXIT Command 102
- FILE Command 103
- Command Reference 104
- INET Command 105
- FORMULA 8200 User’s Guide 107
- LOOKUP Command 108
- MODE Command 109
- PORTSERV Command 111
- REBOOT Command 112
- SNMP Command 113
- SNMP/CONFIG Example 114
- command 114
- A similar display appears: 114
- SYSTEM Command 116
- TFTP Command 117
- TOP Command 118
- UP Command 119
- VBRIDGE Command 120
- Table 5-17 123
- /VBRIDGE/SHOW/BRIDGE 1 126
- Table 5-19 127
- VBRIDGE/SHOW/FWT command 128
- /VBRIDGE/SHOW/FWT 128
- 1 7 0 00:a0:d2:c1:55:01 — 5 128
- 1 33 0 00:60:e8:ff:ff:50 — 0 128
- VLAN Command 129
- Command Summary 131
- RMON Configuration 141
- MIB Support 142
- RMON Configuration 144
- RMON Support 145
- Disabling 146
- RMON Objects 146
- Downloading Software at the 147
- [VxWorks] Prompt 147
- ❑ Castle Rock’s SNMPc 148
- Backing Up 149
- Your Current 149
- Configurations 149
- Configuring for 150
- Download 150
- Downloading 151
- Using FTP/TFTP 151
- [VxWorks Boot]: c 154
- [VxWorks Boot]:@ 154
- Restoring Your 155
- Firmware Upgrade Using Zmodem 156
- [VxWorks Boot]: @ 158
Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis FORMULA 8200
(32 paginas)
(19 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.089 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales