
Chapter 5: Enhanced Stacking
100 Section I: Basic Features
Selecting a Switch in an Enhanced Stack
Before you perform a procedure on a switch in an enhanced stack, you
should first check to be sure that you are performing it on the correct
switch. If you assigned system names to your switches, this should be
easy. The name of the switch being managed is always displayed at the
top of every management menu.
When you start a local or remote management session on the master
switch of an enhanced stack, you are by default addressing that
particular switch. The management tasks that you perform affect only
the master switch.
To manage a slave switch or another master switch in the stack, you
need to select it from the AT-S63 management software.
To select a switch to manage in an enhanced stack, perform the
following procedure:
1. From the Main Menu, type 9 to select Enhanced Stacking.
The Enhanced Stacking menu is shown in Figure 22 on page 99.
2. From the Enhanced Stacking menu, type 2 to select Stacking Services.
Note
Option 2, Stacking Services, is only displayed on master switches.
The Stacking Services menu is shown in Figure 23.
Figure 23. Stacking Services Menu
Allied Telesyn Ethernet Switch AT-9400 Series - AT-S63
Marketing
User: Manager 11:20:02 02-Oct-2004
Stacking Services
Switch Software Switch
Num MAC Address Name Mode Version Model
--------------------------------------------------------------------
1 - Get/Refresh List of Switches
2 - Sort Switches in New Order
3 - Access Switch
4 - Download Image/Bootloader
5 - Download Configuration
R - Return to Previous Menu
Enter your selection?
Comentarios a estos manuales