Allied-telesis AT-S47 Manual de usuario descargar pdf (Pagina 114)

Section III: Command Line Interface

114

Taken together, the two commands SET LOCAL PORT and SET REMOTE

PORT give you complete control over a GBIC port’s ability to send and

receive traffic. To stop a GBIC from transmitting data to its local end

node, you would use the SET LOCAL PORT command, which disables the

GBIC’s laser. To stop a GBIC module from forwarding traffic from its end

node to the multiplexing port, you would use the SET REMOTE PORT

command. If you want to completely shutdown a GBIC port, you would

use both commands.

Note

Do not be confused by the use of LOCAL and REMOTE in these

commands. The terms relate to the internal logic of the multiplexer

and do not relate to ports on different multiplexers.

Examples

The following command stops GBIC ports 3 and 5 from sending data

through the multiplexing port:

set remote port=3,5 mode=shutdown

The following command allows GBIC port 2 to send data through the

multiplexing port:

set remote port=2 mode=active

1 2 ... 109 110 111 112 113 114 115 116 117 118 119 ... 153 154

Sin comentarios

Allied-telesis AT-S47 Manual de usuario Pagina 114