Allied-telesis AT-GS2002/SP Manual de usuario descargar pdf (Pagina 43)

AT-GS2002/SP Gigabit Ethernet to Fiber SFP Media Converter Installation Guide

Powering On the AT-GS2002/SP Media Converter

To power on an AT-GS2002/SP Media Converter, perform the following

procedure:

Note

The AC/DC power adapter shipped with the unit is not used if you

install the AT-GS2002 in an AT-MCR12 chassis. In this case, refer

to the AT-MCR12 Installation Guide for installation of the media

converter into the chassis and the power up instructions.

Note

The AC/DC power adapter shipped with the unit is used if you install

the AT-GS2002 in an AT-TRAY4 or AT-TRAY1 chassis. The

following procedure applies in these cases.

1. Locate the 12 VDC input connector on the rear panel of the AT-

GS2002/SP Media Converter as shown in Figure 11.

Figure 11. Connecting Power Cord to an AT-GS2002 AC Powered

Chassis

2. Plug the DC end of the power cord to the power receptacle connector

labeled 12VDC.

12 VDC

Input Connector

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 51 52

Sin comentarios

Allied-telesis AT-GS2002/SP Manual de usuario Pagina 43