Allied-telesis AT-GS2002/SP Manual de usuario descargar pdf (Pagina 34)

Chapter 2: Installation

Rear Panel DIP Switches Configuration

Before the AT-GS2002/SP Media Converter is installed, the rear panel

DIP switches must be configured for the two Ethernet ports. The DIP

switch are numbered 1 - 4 and each one controls a specific function for a

specific port. The port numbers assigned to each DIP switch are clearly

marked the table on the rear panel. The specific switch functions are given

in Table 7 for the possible settings.

Note

The DIP switch location is shown in Figure 2 on page 19. Port 1

(SFP port) and Port 2 (twisted-pair port) are shown in Figure 1 on

page 19.

When setting the DIP switches, consider the following:

 Setting the Auto Neg DIP switch for the twisted-pair port to ON or

OFF enables or disables Auto-Negotiation for the port. If you

disable Auto-Negotiation, be sure to set the DIP switches for the

port’s speed and duplex mode to match the speed and duplex

mode of the end-node device connected to the converter’s copper

port.

 If you enable Auto-Negotiation, be sure that the end-node device is

also configured for Auto-Negotiation.

Table 7. Rear Panel DIP Switch Settings

DIP

Switch

Number

Port Setting Position Description

AUTO

NEG

UP Auto-negotiation on the twisted-pair port is OFF.

DOWN Auto-negotiation on the twisted-pair port is ON.

SPEED

(Mbps)

UP The twisted-pair port operates at 10 Mbps.

DOWN The twisted-pair port operates at 100 Mbps.

DUPLEX

MODE

UP The twisted-pair port operates in half-duplex mode.

DOWN The twisted-pair port operates in full-duplex mode

41SFP

UP A 100Base-FX SFP module is installed.

DOWN A 1000Base-X SFP module is installed.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 51 52

Sin comentarios

Allied-telesis AT-GS2002/SP Manual de usuario Pagina 34