Allied-telesis AT-9000 Series Manual de usuario descargar pdf (Pagina 119)

AT-9000 Switch Command Line User’s Guide

Resetting the Switch

To reset the switch, use either the REBOOT or RELOAD command in the

Privileged Exec mode. You might reset the switch if it is experiencing a problem

or if you want to reconfigure its settings after designating a new active boot

configuration file. The commands display a confirmation prompt.

Caution

The switch will not forward network traffic while it initializes its

management software. Some network traffic may be lost. The reset can

take from thirty seconds to two minutes, depending on the number and

complexity of the commands in the active boot configuration file.

Note

Any configuration changes that have not been saved in the active boot

configuration file are discarded when you reset the switch. To save your

changes, use the WRITE or COPY RUNNING-CONFIG STARTUP-

CONFIG command in the Privileged Exec mode.

To reset the switch with the REBOOT command:

awplus> enable

awplus# reboot

Are you sure you want to reboot the switch? (y/n) y

To reset the switch with the RELOAD command:

awplus> enable

awplus# reload

Are you sure you want to reboot the switch? (y/n) y

To resume managing the switch, wait for the switch to initialize its management

software and then start a new management session.

For reference information, refer to “REBOOT” on page 124 and “RELOAD” on

page 125.

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 147 148

Sin comentarios

Allied-telesis AT-9000 Series Manual de usuario Pagina 119