Allied-telesis AT-2911GP Network Adapters Manual de usuario Pagina 142

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 152
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 141
AT-2911GP Gigabit Fiber Ethernet PoE+ Adapters Installation and User’s Guide
142
Testing Network Connectivity
This section describes how to test network connectivity for Windows and
Linux networks.
Note
When you are using the fiber optic port, both the adapter and the
switch must be set to the same speed and duplex mode. When you
are using the copper port, set both the adapter and switch to Auto-
Negotiation or the same speed and duplex mode.
Windows To test the network connectivity for the Windows driver software, perform
the following procedure.
Use the ping command to determine if network connectivity is working.
1. Select Run from the Windows Control Panel
The Run command window opens, as shown in Figure 92.
Figure 92. Run Command Window
2. Type cmd and click OK.
3. Type ipconfig /all
The command window opens, as shown in Figure 93 on page 143.
Vista de pagina 141
1 2 ... 137 138 139 140 141 142 143 144 145 146 147 ... 151 152

Comentarios a estos manuales

Sin comentarios