Allied-telesis AlliedView-EMS 4.0.3 Device-Management Manual de usuario Pagina 341

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 468
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 340
AlliedView™-EMS 4.0.3 Device Management Guide Page 341 of 468
Note - The current firmware version returns a 'noSuchName' value for the
Allocation Failures parameter.
Note - The Storage Size parameter is implemented as 'read-only'.
Note - The current firmware version does not return complete values for the
parameters under the Logical Storage Areas table and Device Manager does
not handle Get-Next request for this table correctly. As a result, the Used
Storage Size parameter displays incomplete values.
Note - The Allocation Failures parameter is not applicable to the AT-x900-
12X series and should be ignored.
Host Info
Displays the host information of the device.
Hardware Info
Total Expansion Modules Installed
Displays the number of expansion modules installed in the device.
Installed Modules Info
Displays information about the expansion modules installed in the device.
Note - The current firmware version does not allow the Board Bay
parameter to be configured. Attempting to configure this parameter to any
valid value will result in the error "The error occurred with 'Set' operation.
Error: gen error".
Port Transceivers Info
Displays the type of transceiver on an interface.
Port Events
Displays the number of times that port number values have been re-assigned
since the system was initialized.
Firmware Info
Current Firmware
Displays information about the current software version installed in the
device.
Note - Configuring the Save Current Software parameter to values greater
than its valid range will be accepted but will cause the device to restart
intermittently.
Vista de pagina 340
1 2 ... 336 337 338 339 340 341 342 343 344 345 346 ... 467 468

Comentarios a estos manuales

Sin comentarios