Allied-telesis AT-S97 Manual de usuario descargar pdf (Pagina 54)

Chapter 3: IP Configuration Commands

IP SHOW

Syntax

ip show

Parameters

None.

Privilege Levels

Administrator, read-write, and read-only.

Description

This command is used to view the management module’s IP address,

subnet mask, and default gateway address. An example is shown in

Figure 8.

Figure 8. IP SHOW Command

For further information, refer to the following sections:

 “Overview” on page 48 for background information on when to assign

an IP address configuration to the management module.

 “IP DHCP ENABLE” on page 51 and “IP DHCP DISABLE” on page 50

for instructions on how to activate or deactivate the DHCP and BOOTP

clients.

 “IP SET” on page 52 for instructions on how to manually assign these

values.

Example

ip show

IP Information:

IP Address........... 149.25.42.11

Subnet Mask.......... 255.255.255.0

Gateway.............. 149.25.42.27

DHCP................... Disable

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 247 248

Sin comentarios

Allied-telesis AT-S97 Manual de usuario Pagina 54