Allied-telesis AT-S97 Manual de usuario descargar pdf (Pagina 205)

AT-S85 and AT-S97 Management Software User’s Guide

205

 Telnet server is enabled or disabled

 SSH session is opened or closed

 SSH session is enabled or disabled

 Warm or cold boot of a media converter module

 Management stacking port is up or down

 A module was acquired by or released by the chassis management

 Login authentication failure

 Fan A failure or recovery on either power module or AT-MCF2KFAN

fan

 Fan B failure or recovery on either power module or AT-MCF2KFAN

fan

 Power failure or recovery on a power module

 Chassis has been reset

 Module has been reset

 Low battery or recovery from low battery

 Management module has overwritten media converter module

configuration

 Media converter module has overwritten management module

configuration

Trap receivers are the devices, typically management workstations or

servers, that you want to receive the traps sent by the unit. You specify the

trap receivers by their IP addresses.

Command

Summary

Table 22 summarizes the SNMP commands.

Table 22. SNMP Commands

Command Description

“SNMP SET” on page 206 Sets the SNMPv1 and SNMPv2c

community strings and the IP

addresses of the trap receivers.

SNMP SHOW on page 208 Displays the SNMPv1 and

SNMPv2c community strings and

the IP addresses of the trap

receivers.

1 2 ... 200 201 202 203 204 205 206 207 208 209 210 ... 247 248

Sin comentarios

Allied-telesis AT-S97 Manual de usuario Pagina 205