Allied-telesis AT-S81 Manual de usuario descargar pdf (Pagina 79)

AT-S81 Management Software User’s Guide

Section I: Using the Menus Interface 79

Modify SNMP trap receivers->Enter entry number>

Note

The trap receiver must be one whose status is not “deleted.”

4. Enter the number for the trap you want to modify.

The following prompt is displayed:

Modify trap receiver entry number (I/C/B)>

The options are:

I - Modify the IP address of the trap receiver. To modify only the IP

address, type I and follow the prompts.

C - Modify the community name of the trap receiver. To modify only the

community name, type C and follow the prompts.

B - Modify both the IP address and community name of the trap

receiver. To modify both the IP address and the community name, type

B and follow the prompts.

Deleting a Trap

Receiver

When you delete a trap receiver, all the settings are removed from the

entry in the table. Instead of deleting a trap receiver, you may want to

disable it, as described in “Enabling or Disabling Trap Receivers” on

page 77.

To delete a trap receiver, perform the following procedure:

1. From the Main Menu, type B to select Basic Switch Configuration.

The Basic Switch Configuration Menu is shown in Figure 4 on page 32.

2. From the Basic Switch Configuration menu, type N to select SNMP

Configuration.

The SNMP Configuration menu is shown in Figure 19 on page 75.

3. Type D to select Delete SNMP Trap Receiver.

The following prompt is displayed:

Delete SNMP trap receivers->Enter entry number>

4. Type the number of the entry you want to delete.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 359 360

Sin comentarios

Allied-telesis AT-S81 Manual de usuario Pagina 79