Allied-telesis AT-S81 Manual de usuario descargar pdf (Pagina 222)

Chapter 19: Basic Switch Parameters

222 Section II: Web Browser Interface

Configuring an IP Address, Subnet Mask and Gateway Address

This procedure explains how to change the IP address, subnet mask, and

gateway address of the switch. Before performing the procedure, note the

following:

 An IP address and subnet mask are not required for normal network

operations of the switch. Values for these parameters are only required

if you want to remotely manage the device using the web browser

interface.

 A gateway address is only required if you want to remotely manage

the device from a remote management station that is separated from

the switch by a router.

 To configure the switch to automatically obtain its IP configuration from

a DHCP server on your network, go to “Enabling and Disabling the

DHCP Client” on page 224.

 You must use the menus interface to manually assign an IP address to

the switch, as described in “Configuring an IP Address, Subnet Mask

and Gateway Address” on page 222.

To change the switch’s IP configuration, perform the following procedure:

1. From the Basic Config menu, select IP Config.

The IP Configuration page opens, as shown in Figure 63.

Figure 63. IP Configuration Page

2. Change the IP configuration parameters by entering new information

in the fields:

System MAC Address

This parameter displays the MAC address of the switch. You cannot

change this parameter.

System IP Address

Enter the IP address for the switch.

1 2 ... 217 218 219 220 221 222 223 224 225 226 227 ... 359 360

Sin comentarios

Allied-telesis AT-S81 Manual de usuario Pagina 222