Allied-telesis AT-MCM02 Manual de usuario descargar pdf (Pagina 15)

AT-MCM02 Management Module Installation Guide

Installing the Management Module

To install the management module in your multichannel media converter,

perform the following procedure:

Warning

Installing the AT-MCM02 Management Module while the media

converter is powered ON could result in damage to the module.

1. Power OFF the media converter by performing one of the following:

❑ For an AC model, unplug the power cord from the power outlet and

then unplug the power cord from the media converter.

❑ For a DC model, follow the steps below:

Warning

When installing this equipment, alway ensure that the frame ground

connection is installed first and disconnected last. $ 15

a. Remove the positive and negative feed wires from the terminal block

by loosening the screws to the wire connections with a flathead

screwdriver.

b. Remove the frame ground wire from the terminal block by loosening

the screw to the wire connection with a flathead screwdriver.

2. Using a Phillips-head screwdriver, remove the blank faceplate from the

management module expansion slot, located on the back panel of the

media converter. See Figure 1.

Figure 1 Removing the Blank Faceplate

3. Remove the management module from the package and store the

packaging in a safe place.

Management

Port

Power Supply

Main

Back-Up

AC LINE

100-240 VAC

50-60 Hz

1.5A MAX

50 W

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 51 52

Sin comentarios

Allied-telesis AT-MCM02 Manual de usuario Pagina 15