Allied-telesis AT-CM70S Manual de usuario descargar pdf (Pagina 34)

Chapter 1: Converteon™ Fast Ethernet and Gigabit Ethernet Line Cards

RS-232 Console Port (AT-CM70S Line Card Only)

You can use the console port on the AT-CM70S line card to establish a

local (out-of-band) management session with the chassis to configure

parameters and also view information about the operating of the system

and line cards. You establish a local management session with the

converter by connecting either a terminal, or a personal computer with a

terminal emulation program, to the port.

Note

For more information how to start a management session, refer to

the installation guide that comes with the chassis.

Note

If an AT-CM70S line card is used in an AT-CV5000 chassis, it can

be managed either from its local console or from the console port on

the AT-CV5M01 CPM module. However, if this line card is used in

an AT-CV1200 chassis, it can only be managed from its local

console, as there is no room for an AT-CV5M01 CPM module.

Type of

Connector

The RS-232 console port on the AT-CM70S line card features 8-pin Mini-

DIN connectors. For the port pinouts, refer to “8-Pin Mini-DIN Console

Port Pinouts” on page 93.

Specifications The console port has a Mini-DIN style connector and is set to the following

specifications:

 Baud rate: 115200 bps

 Data bits: 8

 Parity: None

 Stop bits: 1

Type of Cable The console port on the AT-CM70S line card use the RS-232 serial cable.

Note

You can use the AT-S70 management software to change the

terminal port settings.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 135 136

Sin comentarios

Allied-telesis AT-CM70S Manual de usuario Pagina 34