
AT-3726XL, AT-3716XL, and AT-3714FXL Installation Guide
2-5
Rack Mounting the Unit
Do not use power tools to perform the following installation.
To rack mount the unit
1. Remove all cables and power cord from the switch (if previously
attached).
2. Remove the snap-on plastic feet, as shown in Figure 2-1.
Figure 2-1
Removing the Feet
3. Attach the rack-mounting brackets to each side of the switch, using
the 6 flathead screws provided.
Figure 2-2
Attaching Rack-Mounting Brackets
R PORT
RS-232
TERMINAL PORT
STATUS
RESET
FAULT
POWER
Comentarios a estos manuales