Allied Telesis Switch AT-SBXPWRSYS1 Manual de usuario descargar pdf (Pagina 193)

SwitchBlade x3112 Installation Guide

193

2. Connect the other end of the cable to an RS-232 port on a terminal or

personal computer with a terminal emulation program.

3. Configure the VT-100 terminal or terminal emulation program as

follows:

 Baud rate: 115,200 bps

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

Note

The port settings are for a DEC VT100 or ANSI terminal, or an

equivalent terminal emulator program.

4. Press Enter. You are prompted for a user name and password.

5. Enter the default user name and password. They are “manager” and

“friend” (without the quotes), respectively

Note

User names and passwords are case sensitive.

The local management session starts and the command line interface

(CLI) prompt is displayed.

Entering the

Management

Software

Commands

To confirm the operations of the chassis with the commands in the

management software, perform the following procedure:

1. Enter the SHOW SYSTEM command to display the software version

number of the management software on the control card, as shown in

Figure 145.

Figure 145. SHOW SYSTEM Command

SHOW SYSTEM

--- System Information ----------------------------------------------

System Date.................. 2013-07-2

System Uptime................ 2 days, 14 hours, 27 minutes, 18 seconds

Software

Version.................. 17.0.0

Options ................. Customer-Release Build

Created ................. Tue 07/21/2012 at 1:25 PM

Boot From ................... preferred

Software Version

Number

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 221 222

Sin comentarios

Allied Telesis Switch AT-SBXPWRSYS1 Manual de usuario Pagina 193