Allied Telesis AT-FH708E Guía de instalación descargar pdf (Pagina 32)

❑ Check that the power outlet has power by

connecting another device to it.

❑ Try replacing the power adapter with

another power adapter.

2. Check the Link/Act LED for each port. The

LED should be lit steady or flashing. If a

Link/Act LED is OFF, check the following:

❑ Verify that the node connected to the port

on the hub is powered ON. If the node is

OFF, power the unit ON.

❑ Verify that the distance between the hub

and the connected network device is no

greater than 100 meters (328 feet).

❑ Check to be sure that you are using the

correct type of cable: Category 3, 4, or 5 for

10 Mbps operation and Category 5 cable

for 100 Mbps operation.

❑ Verify that the cable has not been cut or

damaged.

3. If the Lnk/Act LED for a port is ON but there

is a communication problem to the end node

connected to the port, such as the loss of data,

check the following:

❑ Check to be sure that the distance

between the hub and the connected

network device is no greater than 100

meters (328 feet).

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 50 51

Sin comentarios

Allied Telesis AT-FH708E Guía de instalación Pagina 32