Allied-telesis FastPrint Server Manual de usuario Pagina 35

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 34
Chapter 5. TCP/IP
Unix host configuration
FastPrint Server User’s Guide 25
5.2.4. Logical printers
The FastPrint Server supports 8 logical printers. The names (L1..L8) cannot be changed.
Each logical printer has 4 settings as shown above. The line numbers in the FastPrint’s
CONFIG file are as follows:
Logical printerLogical printer Line numbersLine numbers
L1 0100 to 0103
L2 0120 to 0123
L3 0140 to 0143
L4 0160 to 0163
L5 0180 to 0183
L6 0200 to 0203
L7 0220 to 0223
L8 0240 to 0243
5.2.4.1. Logical printer setup
Physical port
(0100 L1_PROUT)
FastPrint Port to which the printer is attached
(P1 to P3).
String before job
(0101 L1_PREST)
The printer control string (in hex) to be sent to
the printer before each print job.
String after job
(0102 L1_POSTR)
The printer control string (in hex) to be sent to
the printer after each print job.
Convert LF to CR+LF
(0103 L1_CHGLF)
If ON, LF (line feed) characters are changed to
CR+LF (carriage return + line feed). If OFF, no
conversion is done.
Note: The maximum size of a printer control string is 15 characters.
5.3. Unix host configuration
You must first give the FastPrint Server an IP address so that it will be a valid device on
the LAN.
5.3.1. Static IP address configuration
1. Determine the physical address of the FastPrint Server from the default name shown
on a sticker on the base of the FastPrint. It will be in the form SCxxyyzz (SC
followed by 6 hex numbers). If its name is SCxxyyzz, then the physical address is
00:c0:02:xx:yy:zz.
2. Login to the UNIX host as root.
3. Add the FastPrint to the /etc/hosts file by adding the following line to the file:
IP_Address NAME # comment
Vista de pagina 34
1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 99 100

Comentarios a estos manuales

Sin comentarios