Allied-telesis FastPrint Server Manual de usuario Pagina 13

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 100
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 12
Chapter 1. Introduction
Features
FastPrint Server User’s Guide 3
1.2.1. LED Indicators
There are two LED indicators on the top of the FastPrint Server. The red LED is the
Status/Error indicator. The green LED is the Power/Link indicator. See the previous
figures to locate the LEDs on your model. The LED indicator modes are described in the
following table.
Green LEDGreen LED Red LEDRed LED Status DescriptionStatus Description
Solid Off Solid Off No power.
Solid On Solid On Hardware error.
Solid On Solid Off Normal operation.
Flashing Off Transmitting or receiving
packets from the network.
Table 1: LED Indicators
1.2.2. 10/100BaseT Switches
The FastPrint has 2 DIP switches. See the previous diagrams to locate these switches.
Operation of these switches is described below.
SwitchSwitch DescriptionDescription
1
Auto Negotiation Switch.
When ON (UP position), the FastPrint will
select 10BaseT/100BaseT and Full/Half
Duplex as required. The recommended
position is ON; switches 2 & 3 are disabled
when Auto Negotiation is ON.
2
10/100BaseT Manual Select Switch.
Set UP for 100BaseT or DOWN for 10BaseT.
Switch 1 must be OFF for this switch to
function.
3
Full/Half Duplex Switch.
Set UP for Full duplex operation or DOWN for
Half Duplex operation.
Switch 1 must be OFF for this switch to
function.
Table 2: DIP Switches
Vista de pagina 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 99 100

Comentarios a estos manuales

Sin comentarios