
AT-TQ3600 Wireless Access Point Installation Guide
27
Operating Temperature. This product is designed for a maximum
ambient temperature of 40° degrees C with the AC/DC adapter and
45° degrees C with Power over Ethernet.
Do not touch the heat sinks inside the access point. Refer to Figure
10 on page 35.
To reduce the risk of electric shock, the PoE ports on this product
must not connect to cabling that is routed outside the building where
this device is located. E40
This equipment is intended for indoor use only.
Do not touch the captive screw on the front panel when the wireless
access point is operating because it can reach a high temperature.
All Countries: Install product in accordance with local and National
Electrical Codes. E8
This product is not approved for use in a computer room as defined
in the Standard for Protection of Electronic Computer/Data
Processing Equipment, ANSI/NFPA 75.
If you are not using PoE to power to the unit, use only an approved
AC/DC adapter.
You should verify that your PoE network adheres to the standards of
a SELV (separated extra-low voltage) circuit before using the PoE
feature on the wireless access point.
Comentarios a estos manuales