Allied-telesis AT-S81 Manual de usuario descargar pdf (Pagina 145)

AT-S81 Management Software User’s Guide

Section II: Menus Interface 145

Enabling or Disabling RSTP

To enable or disable RSTP, perform the following procedure:

1. From the Main Menu, type B to select Basic Switch Configuration.

The Basic Switch Configuration Menu is shown in Figure 4 on page 32.

2. From the Basic Switch Configuration Menu, type S to select Rapid

Spanning Tree Configuration.

The Rapid Spanning Tree Configuration Menu is shown in Figure 34.

Figure 34. RSTP Configuration Menu

The RSTP menu allows you to configure RSTP as well as to view the

current settings and contains the following items of information in the

middle portion:

Root Port

The active port on the switch that is communicating with the root

bridge. If the switch is the root bridge for the LAN, then there is no root

port and the root port parameter will be 0.

Root Path Cost

The sum of all the root port costs of all the bridges between the

AT-8000/8POE Local Management System

Advanced Switch Configuration -> Rapid Spanning Tree Configuration Menu

Global RSTP Status: Disabled Protocol Version: RSTP

Root Port: 0 Time Since Topology Change: 118 Sec.

Root Path Cost: 0 Topology Change Count: 1

Designated Root: 8000 00C08F1211BB Bridge ID: 8000 010203AABB04

Hello Time: 2 Sec. Bridge Hello Time: 2 Sec.

Maximum Age: 20 Sec. Bridge Maximum Age: 20 Sec.

Forward Delay: 15 Sec. Bridge Forward Delay: 15 Sec.

----------------------- <COMMAND> -----------------------------

[E]nable/Disable Global RSTP Set Bridge [F]orward Delay

Set RSTP Protocol [V]ersion RSTP [B]asic Port Configuration

Set Bridge [P]riority RSTP [A]dvanced Port Configuration

Set Bridge [H]ello Time Topology [I]nformation

Set Bridge [M]aximum Age [Q]uit to previous menu

Command>

1 2 ... 140 141 142 143 144 145 146 147 148 149 150 ... 313 314

Sin comentarios

Allied-telesis AT-S81 Manual de usuario Pagina 145