Allied-telesis AT-S63 Manual de usuario Pagina 117

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 514
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 116
AT-S63 Management Software Features Guide
Section II: Advanced Operations 117
Observe this guideline when using these criteria:
The Protocol variable must be left blank or set to IP.
TCP Source Ports (Layer 4)
TCP Destination Ports (Layer 4)
A traffic flow can be identified by a source and/or destination TCP port
number contained within the header of an IP frame. Observe the following
guidelines when using these criteria:
The Protocol variable must be left blank or set to IP.
The IP Protocol variable must be left blank or set to TCP.
A classifier cannot contain criteria for both TCP and UDP ports. You
may specify one in a classifier, but not both.
UDP Source Ports (Layer 4)
UDP Destination Ports (Layer 4)
A traffic flow can be identified by a source and/or destination UDP port
number contained within the header of an IP frame. Observe the following
guidelines when using these criteria:
The Protocol variable must be left blank or set to IP.
The IP Protocol variable must be left blank or set to UDP.
A classifier cannot contain criteria for both TCP and UDP ports. You
may specify only one in a classifier.
TCP Flags
A traffic flow can be based on the following TCP flags:
URG - Urgent
ACK - Acknowledgement
RST - Reset
PSH - Push
SYN - Synchronization
FIN - Finish
Observe the following guidelines when using this criterion:
The Protocol variable must be left blank or set to IP.
The IP Protocol variable must be left blank or set to TCP.
A classifier cannot contain both a TCP flag and a UDP source and/or
destination port.
Vista de pagina 116
1 2 ... 112 113 114 115 116 117 118 119 120 121 122 ... 513 514

Comentarios a estos manuales

Sin comentarios