Allied-telesis AT-MCF2012LC/1 Manual de usuario descargar pdf (Pagina 37)

AT-MCF2012LC and AT-MCF2012LC/1 Media Converter Modules Installation Guide

SML LEDs, explained in “LT, ML, and SML Channel

Operating Mode LEDs” on page 30. A change of the

operating mode is immediately activated on a channel.

Here is an example on how to use the Mode Selection

button. Assume you wanted to determine the duplex mode

of the two port in channel 6 (i.e., twisted pair port 6 and fiber

optic port 6) and change the operating mode of the channel

to the Link Test mode. The first step is select channel 6 by

turning the Mode Selection button up or down to toggle the

CH LEDs until the CH6 LED under fiber optic port 6 is on. At

that point the CDC and FDC LEDs immediately reflect the

duplex mode and collisions for the two ports of channel 6.

To change the operating mode of the channel to the Link

Test mode, you press the button to toggle the operating

mode LEDs until the LT LED is on.

Note

Using the Mode Selection button to view the CDC and

FDC LEDs and to change the operating mode of a

channel does not interfere with the forwarding of traffic

by the channels on the module.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 63 64

Sin comentarios

Allied-telesis AT-MCF2012LC/1 Manual de usuario Pagina 37