Allied-telesis AT-iMG6x6MOD Electronics Unit Manual de usuario Pagina 18

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 46
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 17
AT-iMG646MOD Installation Guide
18 Chapter 3: Installing the Gateway in the Enclosure
6. Trim the wire tie and seal the grommet with tape and silicone sealant.
Caution
The grommet must be sealed so that the unit can operate correctly in an outside environment.
Prepare for Initial Startup
To complete the installation, perform the following procedure:
1. Install an uninterruptible power supply according to the manufacturer’s instructions.
2. If necessary, plug the management cable into the console port. For networks with remote management
enabled, no local configuration is required.
3. The physical installation is now complete, as shown in Figure 12.
Figure 12. Configuration Complete
Vista de pagina 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 45 46

Comentarios a estos manuales

Sin comentarios