Allied-telesis AT-GS950/48 Manual de usuario Pagina 294

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 410
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 293
Chapter 21: Security
294
Telesis.
The TACACS+ server must communicate with the
switch through a port that is an untagged member of
the Default VLAN and is configured for Forced-
Authorized (802.1x) port control.
If the TACACS+ server is on a different subnet from
switch, be sure to specify a System Default Gateway in
the IP Setup Page, so that the switch and server can
communicate with each other via the gateway. See
“Configuration of IPv4 Address, Subnet Mask and
Gateway Address” on page 32.
You must specify the user name and password
combinations when configuring the TACACS+ server
software on the authentication server.
Note
This guide does not explain how to configure TACACS+ server
software. Refer to the documentation that comes with the TACACS+
server software for instructions.
You must activate the TACACS+ software on the
switch using the AT-S116 Management Software and
configure the settings. This is explained in “Port
Access Control Configuration” on page 285 and
“TACACS+ Configuration”.
TACACS+
Configuration
To configure TACACS+, perform the following procedure:
1. From the main menu on the left side of the page, select the Security
folder.
The Security folder expands.
2. From the Security folder, select TACACS+.
The TACACS+ Page is displayed. See Figure 116.
Figure 116. TACACS+ Page
Vista de pagina 293
1 2 ... 289 290 291 292 293 294 295 296 297 298 299 ... 409 410

Comentarios a estos manuales

Sin comentarios