Allied-telesis AT-GS950/16 Manual de usuario descargar pdf (Pagina 105)

AT-GS950/16 Web Interface User Guide

105

Modify a Port Trunk

This procedure explains how to change the status of a port trunk and add

or remove ports from a port trunk.

Caution

Before you disable or modify a port trunk, disconnect all of the

cables from the ports of the trunk. Leaving the cables connected

during the reconfiguration of a trunk can create loops in your

network topology. Loops can result in broadcast storms which can

severely limited the effective bandwidth of your network.

To add or remove ports from a trunk, perform the following procedure:

1. Disconnect all of the Ethernet cables from the ports of the trunk.

2. Select the Bridge folder.

The Bridge folder expands.

3. From the Bridge folder, select the Trunk Config folder.

The Trunk Config folder expands.

4. From the Trunk Config folder, select Trunking.

The Trunking Page is shown in Figure 36 on page 103.

5. Click the pull-down menu of the port trunk you want to modify and

change the status to one of the following options:

Disable - Disables the port trunk.

Active - The aggregator will broadcast and respond to LACPDU

packets. This setting enables the LACP feature.

Passive - The aggregator will not broadcast LACPDU packets, but

it will respond to them. This setting enables the LACP feature.

Manual - Enables static port trunking and disables the LACP

feature.

6. To add or remove a port from a trunk, click the check box for the port in

the corresponding trunk row.

A check in a box indicates the port is a member of the trunk. No check

means the port is not a member. A port trunk can contain up to

10 ports.

7. Click Apply.

8. From the main menu on the left side of the page, select Save Settings

to Flash to permanently save your changes.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 403 404

Sin comentarios

Allied-telesis AT-GS950/16 Manual de usuario Pagina 105