Allied-telesis AT-FS202SC/FS4 Manual de usuario descargar pdf (Pagina 23)

AT-FS20x and AT-FS202SC/FSx Series Installation Guide

3. Configure the DIP switches. Refer to Figure 3 on page 2 for the location of

the DIP switches and Table 6 for the possible settings.

When setting the DIP switches, consider the following:

❑ Setting the Auto Neg DIP switch for the twisted pair port to ON or

OFF enables or disables auto-negotiation for the port. If you disable

auto-negotiation, be sure to set the DIP switches for the port’s speed

and duplex mode to match the speed and duplex mode of the end-node.

❑ For the fiber optic port, set the port’s duplex mode using the

appropriate Duplex Mode DIP switch. This setting must match the

duplex mode capability of the end-node to be connected to the port.

4. If you are installing the switch in an AT-MCR12 chassis, refer to the

chassis’ installation guide for instructions on how to install the switch,

then proceed to Step 7.

Table 6 DIP Switch Settings

DIP

Switch

Number

Port Setting Position Description

12Speed (Mbps)Up

Down

The twisted pair port is operating at 10

Mbps.

The twisted pair port is operating at 100

Mbps.

2 1 Duplex Mode Up

Down

The fiber optic port is operating at half-

duplex mode.

The fiber optic is operating at full-duplex

mode.

3 2 Duplex Mode Up

Down

The twisted pair port is operating at half-

duplex mode.

The twisted pair port is operating at full-

duplex mode.

42Auto NegUp

Down

Auto-negotiation on the twisted pair port is

OFF.

Auto-negotiation on the twisted pair port is

ON.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 41 42

Comentarios a estos manuales

Sin comentarios

Allied-telesis AT-FS202SC/FS4 Manual de usuario Pagina 23

Comentarios a estos manuales

Relacionado con productos y manuales para Hardware De La Computadora Allied-telesis AT-FS202SC/FS4