Allied-telesis AT-9448Ts/XP (Basic Layer 3) Manual de usuario Pagina 44

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 106
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 43
Chapter 2: Installing the Hardware
44
Installing the Switches in an Equipment Rack
Note
Installing a stack on a table or desktop is not recommended
because it may create a hazardous work area.
Perform the following procedure to install the switches in a standard
19-inch rack:
1. Place the switch upside down on a level, secure surface.
2. Using a flat-head screwdriver, remove the snap-on plastic feet from
the bottom of the switch, as shown in Figure 15.
Figure 15. Removing the Feet
3. Turn the switch over.
4. Attach a rack-mount bracket to one side of the switch using four of the
screws that come with the switch, as shown in Figure 16.
Figure 16. Attaching Rack-Mount Brackets
Vista de pagina 43
1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 105 106

Comentarios a estos manuales

Sin comentarios