Allied-telesis AT-2972T/2 Manual de usuario descargar pdf (Pagina 31)

Advanced Control Suite User’s Guide

in Wake on LAN mode. By default, the WOL Speed property is set to

Auto.

Note

This parameter is available only for copper devices and is not

displayed for the AT-29xxSX Series adapters.

– 10 Mb. Sets the speed to 10 Mbit/s. This is the network speed

when the system is in a standby mode awaiting a wake-up frame.

– 100 Mb. Sets the speed to 100 Mbit/s.

– Auto (default). Sets the speed for optimum network connection.

Network Test

Tab

In the Network Test tab, you can verify IP network connectivity. This test

verifies if the driver is installed correctly and tests connectivity to a

gateway or other specified IP address on the same subnet. The Network

test uses TCP/IP, as shown in Figure 6.

Figure 6. Network Test Tab

Diagnostics Tab On the Diagnostics tab you can perform diagnostic tests on Allied Telesis

network adapters. You use this function to test the physical components of

the adapter, as shown in Figure 7 on page 32.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 75 76

Sin comentarios

Allied-telesis AT-2972T/2 Manual de usuario Pagina 31