Allied-telesis AT-2972T/2 Manual de usuario descargar pdf (Pagina 27)

Advanced Control Suite User’s Guide

Advanced Tab This section describes the Advanced tab, as shown in Figure 5

Figure 5. Advanced Tab

The Advanced tab contains the following fields:

 802.1p QOS. The 802.1p QOS property enables quality of service,

which is an Institute of Electrical and Electronics Engineering (IEEE)

specification that treats different types of network traffic differently to

ensure required levels or reliability and latency according to the type of

traffic. This property is disabled by default. Unless the network

infrastructure supports QoS, do not enable QoS. Otherwise, problems

may occur.

 Checksum Offload. Normally the Checksum Offload function is

computed by the protocol stack. When you select one of the

Checksum Offload property values (other than None), the checksum

can be computed by the network adapter.

– Rx TCP/IP Checksum. Enables receive TCP, IP, and UDP

checksum offloading.

– Tx TCP/IP Checksum. Enables transmit TCP, IP, and UDP

checksum offloading.

– TX/Rx TCP/IP Checksum (default). Enables transmit and receive

TCP, IP, and UDP checksum offloading.

– None. Disables checksum offloading.

 Ethernet@Wirespeed

. The Ethernet@Wirespeed property enables

a Gigabit Ethernet adapter to establish a link at a lower speed when

only 2 pairs of wires are available in the cabling plant. By default, this

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 75 76

Sin comentarios

Allied-telesis AT-2972T/2 Manual de usuario Pagina 27